![]() Press the green check mark ( √ ) again the DP mode will change from DP 1.2 to DP1.1.Press the green check mark ( √ ) button for about 8 seconds and the following dialogue box will appear, "Set MST option to secondary".Press any key again and the "input source" menu will appear.Press any key (excluding power button) to show the following dialogue box "There is no signal coming from your computer".You are basically changing the monitor’s Display Port modes from DP 1.2 to 1.1 The following "Hot Keys" will change the MST settings to MST Secondary. With older video drivers, there is a chance of getting No Video when the monitor MST is set to "Off" or "Primary". If your system only supports DP version 1.1, monitor may get No Video condition.The monitor can now get the resolution of 3840x2160 The current resolution can be verified on lower left side of monitor menu.Note: The D3100 Dell Docking Station-USB 3.0 does not support Multi-Stream Transport (MST) (Daisy-Chaining of DisplayPort Displays). It may be necessary to restart the computer for monitor settings to activate.Through the Monitor’s On-Screen Display menu (OSD), change the option from MST "OFF" to MST "Secondary" (You are changing the monitor’s setting from DP 1.2 to 1.1).It will support lower 60 Hz resolutions such as 2560x1440 or 1920x1080. If computer supports DP version 1.1, monitor will not be able to achieve 3840x2160 60hz.MST Secondary: (DP1.1 for daisy chain and single display setup) MST function disabled for secondary monitor in Daisy Chain setup Expected resolution is 4k*2k 30Hz with MST (DP out) disabled.Expected resolution is 4k*2k 30Hz with MST (DP out) enabled. MST Primary: (DP1.2 mode for daisy chain setup) MST function enabled for primary monitor in Daisy Chain setup.MST Off: (DP1.2 mode for single monitor setup) Default mode: 4k*2k 60Hz with MST function Disabled.The display Multi-Stream Transport (MST) should be set to "Off" which is default condition. If your system supports DP version 1.2, the monitor can display the resolution of 3840x2160 60hz.If the Mini-DisplayPort (mDP) connection on the display is used, then the input selection of the On-Screen Display (OSD) will need to be changed to mDP.Ĭonfirm The DisplayPort (DP) Configuration Of The Display ![]() If this is manually changed it must match the input being used or no display will result. The default input setting is set to full size Display Port. For Dell shipped graphic adapters: The Dell support websiteĮnsure That The Display Video In Setting Of The Display Matches The Cable Input Used.Note: If your operating system is Linux then 4k resolution may not be obtainable or may only be obtained 30Hz when using Thunderbolt or USB Type-C adapters.Įnsure That You Have The Most Current Drivers For Your Graphics Adapter
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |